Simple mendelmax psu mount for common 12v 30a PSUs
6
Likes
217
Downloads
644
Views
Published on December 8, 2012
Description
I wanted to mount my PSU to the side of my mendelmax, but couldn't find any mounts that suited me. My criteria were:
No need to use expensive t-nuts you insert from the side of the extrusion, and no disassembly.
Unobtrusive and cheap (in terms of plastic.)
No need to use expensive t-nuts you insert from the side of the extrusion, and no disassembly.
Unobtrusive and cheap (in terms of plastic.)
Instructions
Print. Hold in place, bolt through the hole to the PSU with a 30mm M4 bolt, through a washer.
I was surprised at how well just two of these hold the psu, if you want to you can slightly wobble the top, but it's certainly good enough for me.
I was surprised at how well just two of these hold the psu, if you want to you can slightly wobble the top, but it's certainly good enough for me.
License
Simple mendelmax psu mount for common 12v 30a PSUs by jamesglanville is licensed under the Attribution - Creative Commons license.
More from jamesglanville
More from 3D Printer Parts
You must be logged in to post a comment.