Ultimaker Linear Bearing Pusher
by cbrinker, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
I had not quite gotten the X/Y bearings flush in the extruder head. Rather than take the whole thing apart, I made this thing to put on a rod and use the block to help push the bearing into the head.
Print out at 100% infill.
Place the piece around the rod that goes into extruder hot end. Next use the block + this thing to gently push the bearing further into the head. DO NOT use the rods to push against as you might bend them, instead use your thumb to push with.
If you push too far, you can use the block on the opposite side to correct it.
Make sure to remove this thing before you restart your machine.
NOTE: I have shaved off 0.2 mm off the ID and OD of this thing so that it fits snuggly around the rod as a previous version didn't fit. This could have been a limitation of my printer not be completely calibrated so YMMV.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Ultimaker Linear Bearing Pusher by cbrinker is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving cbrinker a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure cbrinker would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).