Delta Wing Race Car
12
Likes
1304
Downloads
1738
Views
Published on December 9, 2012
Derived from
Pin Connectors V2
by tbuser
Description
Arguably the most interesting, but certainly the most controversial race car design in years. A clean-sheet design that keeps pace with traditional racecars without using wings, a big engine, or even the usual rectangular footprint. Ben Bowlby explains it better than I can: youtu.be/c_INdbXMqsw?t=6m37s
Instructions
Print one body, two front wheels, two rear wheels, two rear wheel spacers, and one steering wheel. The rear wheels should be printed with raft. You'll need 6 pins. The exhaust is kind of a pain to print, you can skip it if you like. The parts are scaled to about 1/20.
No longer a work in progress, rear wheels have been redesigned slightly and a right-side mirrored version of the rear wheel spacer has been added.
Delta1 is a one-piece version scaled for the build platform of a Cupcake (about 1/50).
No longer a work in progress, rear wheels have been redesigned slightly and a right-side mirrored version of the rear wheel spacer has been added.
Delta1 is a one-piece version scaled for the build platform of a Cupcake (about 1/50).
License
Delta Wing Race Car by petropixel is licensed under the Attribution - Share Alike - Creative Commons license.
More from petropixel
More from Vehicles
You must be logged in to post a comment.