Koss Boombox Handle
by gr5, published
If you have a Koss boom box and broke the handle here is an alternate.
This part was slightly too large for my Ultimaker (by about 1 mm). So be aware if you use CURA that it might auto-reduce the size by a scale factor. I ended up heating the part up later with a heat gun and stretching it a little.
The two pins on the sides have support structure built into the stl file so you don't need to print support structure but you will need to remove it afterwards with wire cutters or similar.
Liked ByView All
Give a Shout Out
Koss Boombox Handle by gr5 is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure gr5 would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).