by mamclain, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
A Mermaid Model that is made from a bunch of derivatives
You might need to scale this model to fit your printer, and reasonable scaling should produce good results.
You should probably print this with support material enabled, although if you modify the arm angle in blender you might be able to get it to print without support.
I removed my support up with a pair of wire cutters and did some smoothing with a nail file and a Rotary Tool. Be careful on the hands as the fingers are rather fragile.
I Printed with ABS White plastic
Be warned this model is not open scad friendly out of the box; blender is the recommended editing software for this model.
This model could use some more refinement and segment scaling and smoothing to look better. Nevertheless, this model was designed based upon the fact that printing acts like a mechanical filter that will remove most of the joint imperfections; However, feel free to clean it up in blender.
I like to run my printer slow and steady since my print deck has a tendency to dance around a bit so your configurations will vary.
I printed it with the following slicer settings
Layers and Perimeters
Layer height .3
Vertical shells 2
Solid layers 4 top and 2 bottom
Fill Density .25
Solid infill every 6
Fill angle 45
Solid infill threshold area 70
Small perimeters 50
Solid infill 50
Top solid infill 50
Support material 60
Gap fill 40
Filament and Temperature
I was printing with 1.75mm filament with a bed temperature between 95C to 110C and a hot end temperature of 220.
Mermaid by mamclain is licensed under the Creative Commons - Attribution - Non-Commercial license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving mamclain a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure mamclain would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).