MakerBottable 3x2x1 Rubik's Cube, v5
16
Likes
324
Downloads
942
Views
Published on December 10, 2012
Description
I redesigned my printable MakerBottable 3x2x1 Rubik's Cube v4 in OpenSCAD, using Tony Buser's pin connection system.
I just designed this, so I haven't tested it yet.
Update: I forgot to mention that I created two print plates - one designed for the Thing-O-Matic (marked ToM) and the other for the Replicator (marked Rep1). They are identical parts, but with the Rep1 they are placed farther apart.
I just designed this, so I haven't tested it yet.
Update: I forgot to mention that I created two print plates - one designed for the Thing-O-Matic (marked ToM) and the other for the Replicator (marked Rep1). They are identical parts, but with the Rep1 they are placed farther apart.
Instructions
1. Print
2. Assemble
2. Assemble
You must be logged in to post a comment.
License
MakerBottable 3x2x1 Rubik's Cube, v5 by MakerBlock is licensed under the Attribution - Share Alike - Creative Commons license.
More from MakerBlock
More from Toy & Game Accessories
is it hollow inside? because otherwise it cost to much material.
I did not design the parts with hollow spaces inside specifically because you can specify how much plastic you want inside when you print it. All of the parts print very quickly and I would estimate that it probably only uses about... $0.05-$0.10 in plastic.