6mm Fan Mount and Duct Connector
1
Likes
67
Downloads
625
Views
Published on December 11, 2012
Description
A mount for a 6mm fan attached to a 3" duct.
Instructions
To prvide ehaust for any encased 3D printer.
Parts required:
Drill
6mm 12v cooling fan
3" Ducting
4x 3'4" machine screws
4x 2" machine screws
4 6-32 washers.
8 6-32 nuts
Instructions:
Print both parts.
place 6mm fan into _bottom and drill holes.
Use machine screws to attach the fan.
Add a washer below the fan to prevent scraping(if necessary).
Align, drill holes and attach the top with machine screws.
I covered the connecting surfaces with duct tape to seal any leaks.
I'd like to make this more powerful. Maybe a 120mm fan.
Parts required:
Drill
6mm 12v cooling fan
3" Ducting
4x 3'4" machine screws
4x 2" machine screws
4 6-32 washers.
8 6-32 nuts
Instructions:
Print both parts.
place 6mm fan into _bottom and drill holes.
Use machine screws to attach the fan.
Add a washer below the fan to prevent scraping(if necessary).
Align, drill holes and attach the top with machine screws.
I covered the connecting surfaces with duct tape to seal any leaks.
I'd like to make this more powerful. Maybe a 120mm fan.
License
6mm Fan Mount and Duct Connector by Parkster is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Accessories
You must be logged in to post a comment.