Advent Day 11 Gingerbread house no support required
6
Likes
92
Downloads
1025
Views
Published on December 11, 2012
Derived from
Advent Calendar Day 11
by pleppik
Description
This is the Gingerbread house that required no support to print it out.
The back is sliced off, but still looks good in or out of it's box.
The back is sliced off, but still looks good in or out of it's box.
Instructions
Print it, the front will look a little more like gingerbread layers as it's on a slight angle to help the roof features print.
The points on the roof should print fine if you use 0.2mm layers or smaller. Use 2 or 3 solid layers.
The points on the roof should print fine if you use 0.2mm layers or smaller. Use 2 or 3 solid layers.
License
Advent Day 11 Gingerbread house no support required by RichRap is licensed under the Attribution - Creative Commons license.
More from RichRap
More from Toys & Games
You must be logged in to post a comment.