Air propelled Car with tapered axels
4
Likes
562
Downloads
1171
Views
Published on December 12, 2012
Derived from
Air propelled Car
by DocTatur
Description
The original 5mm diameter axels would not fit in the 4.7mm diameter holes (as printed). So, rather than fix my printing error, I made some tapered axels that fit quite nicely in the holes.
Instructions
I printed the body at 15% infill, 0.27mm layer height with exterior support.
The rest of the parts were printed at 50%. Only the axels need exterior support, but I plated all the non-body parts for unattended printing.
The original parts are included for completeness.
The rest of the parts were printed at 50%. Only the axels need exterior support, but I plated all the non-body parts for unattended printing.
The original parts are included for completeness.
License
Air propelled Car with tapered axels by benstoltz is licensed under the Attribution - Creative Commons license.
More from benstoltz
More from Mechanical Toys
You must be logged in to post a comment.