Weeping Angel tree topper
by cerberus333, published
newer version here:
A tree topper angel with a Dr. Who twist
Note It does have a conical hole up the bottom
to accomodate a tree top branch.
I added a version without the conical hole
in case some want it as a 'solid'statue.
I am submiting this as an entry into ProtoParadigm's Winter Wonderland Contest
Recent Commentsview all
Liked Byview all
Give a Shout Out
My initial print was 0% infill 2 shells 80mm/sec.
I am not happy with my results. I will try again at 40 mm/sec 1 shell 0% infill
will update with results.
I got better results at 40 mm/sec
230 degrees extruder
25 degrees heated bed
I wanted the hollow look. infill might be a good idea,
the head top sags in slightly at the 0% infill