Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
X-Ends for ACME Screws and LM10UU
4
Likes
186
Downloads
1067
Views
Published on December 23, 2012
Description
These are X-Ends for my MendelMax printer which is built with ACME screws and 10mm rods on Z axis
Instructions
Print one X-End iddler and one X-End motor mount.
Attach LM10UU with tie-raps.
screw ACME nuts with 2mm screws.
Attach LM10UU with tie-raps.
screw ACME nuts with 2mm screws.
You must be logged in to post a comment.
License
X-Ends for ACME Screws and LM10UU by dbozec is licensed under the Attribution - Share Alike - Creative Commons license.
More from dbozec
More from 3D Printer Parts
This thing has a serious problem if you think you try to use it for a Prusa/Mendel/MendelMax. The motor mount position is wrong, causing the Y-axis position of the belt to be too close to the middle of the X-axis. It doesn't line up with the belt clamp on X carriages. I don't see how this part could possibly work with the above-mentioned RepRap printers.
Yes I recently saw that the X-belt is just above the rear X-rod, I forgot to check that during modeling.
It does'nt line up with most X-carriages, but it can work with some adjustments on my MendelMax for first prints. I'll update it with a better design when I'll be able to print.