Blokart GPS or anything else holder
by Wired1, published
Bought this GPS speedo for my Blokart but it doesn't have a useful way of mounting it on the handle bar shaft so I designed this.
This needs to be printed out the way it comes to ensure the layers have the correct orientation to prevent splitting.
Print it out then slide it onto the handle bar shaft from the bottom, it will spread slightly as it passes the bend near the top and this is why it has the split down the side.
Use two M3 machine screws approximately 15mm long and 2 x M3 nuts.
Secure the GPS with a couple of 3mm x100mm cable ties as per the photos.
Liked ByView All
Give a Shout Out
Blokart GPS or anything else holder by Wired1 is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
We're sure Wired1 would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).