Table Cable Clip / Holder
21
Likes
215
Downloads
864
Views
Published on December 15, 2012
Description
A cable clip / holder capable of keeping three cables from falling from the table.
UPDATE: Added a hollow version. It allows to print the holder and fill it with a heavier material to improve friction. There is also a file for the base to cap up the holder after filling.
UPDATE: Added a hollow version. It allows to print the holder and fill it with a heavier material to improve friction. There is also a file for the base to cap up the holder after filling.
Instructions
Printing is pretty straightforward. Should be printed at lowish speed, at least the top part. Otherwise support might be necessary and the top will not print cleanly.
To prevent the clip itself from sliding from the surface, use either double sided tape or some sort of anti slip or high friction material. I glued tennis bat wrapping material to the bottom of it and while far from perfect, it does the job for me.
The hollow version should be printed with support.
To prevent the clip itself from sliding from the surface, use either double sided tape or some sort of anti slip or high friction material. I glued tennis bat wrapping material to the bottom of it and while far from perfect, it does the job for me.
The hollow version should be printed with support.
You must be logged in to post a comment.
License
Table Cable Clip / Holder by DavidRiesenberg is licensed under the Attribution - Share Alike - Creative Commons license.
More from DavidRiesenberg
More from Organization
That's a very good idea and I have been toying with it myself. Personally, I am not sure that I prefer it over the full version, but I added the files for it. I also added a base to cap the body after filling it.