Toothbrush holder for Oral-B / Braun
by viresx, published
Recent Commentsview all
I use Slic3r 0.9.9 and had no problems :)
Slic3r exports to binary STL instead of ASCII STL, so I'll add binary file too.
I like it!
Slic3r however did not, 0.9.10b crashes while slicing. Repair in Netfabb did not work, Load, export from Slic3r to STL then import it did work.
This is the first household type that made the cut (usefull enough) and got installed.
Liked Byview all
Give a Shout Out
2. Adjust top holdings by cutting it a little to make sure toothbrush tip fits perfectly and is easy to remove.
3. Use double-sided tape to mount it to a wall
Version v2 (printed red):
Color rings are visible and water doesn't stay inside hole.
You must be logged in to post a comment.