Soda Siphon Fill Tube Extractor
0
Likes
91
Downloads
565
Views
Published on December 17, 2012
Description
Replacement extractor for removing the fill tube from an iSi soda siphon or seltzer bottle.
Works best with a spoon through the handle to provide better grip. I couldn't print a bigger handle on my print bed. Will fit on 150x150 bed.
The large version is the same except for having a bigger handle that you can actually grip sufficiently to remove the fill tube.
Works best with a spoon through the handle to provide better grip. I couldn't print a bigger handle on my print bed. Will fit on 150x150 bed.
The large version is the same except for having a bigger handle that you can actually grip sufficiently to remove the fill tube.
Instructions
Printed at .2mm layer with 50% fill, which is probably tougher than it needs to be.
You must be logged in to post a comment.
License
Soda Siphon Fill Tube Extractor by lthomas987 is licensed under the Attribution - Share Alike - Creative Commons license.
More from lthomas987
More from Kitchen & Dining
This reminds me of the key from Goldeneye!
http://www.collectorsquest.com...
The large version.