Loading

Solidoodle doorknob

by cmetzel, published

Solidoodle doorknob by cmetzel Dec 18, 2012

Description

Doorknob that fits into opening for Solidoodle 2, intentionally a hair oversize for a press fit, may need to dust off high points if you don't want to press that hard.

Recent Comments

view all
I broke one clean off but all the rest cracked and where barely held on.I acetone glued it on though, works great. Thanks again cmetzel.
Don't feel bad I broke 3 teeth.

Broke the first one trying to see how strong the horizontally bonded plastic would be. Then two more because it wasn't symmetrical and I'm OCD like that.

Does make a great doorknob :)
Yeah you need to hit the high points with a file if it won't go in at first. It's just tight to prevent rattling.

More from 3D Printer Accessories

view more

Makes

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

I printed at .3mm, no support required.

I broke one clean off but all the rest cracked and where barely held on.I acetone glued it on though, works great. Thanks again cmetzel.
I had to break 2 teeth to make it go in the hole.
But then it worked great.
It stays there when I pull.
No slack.
Don't feel bad I broke 3 teeth.

Broke the first one trying to see how strong the horizontally bonded plastic would be. Then two more because it wasn't symmetrical and I'm OCD like that.

Does make a great doorknob :)
Yeah you need to hit the high points with a file if it won't go in at first. It's just tight to prevent rattling.
Top