Polar Bear cub
by cerberus333, published
Modeled in sculptris
Recent Commentsview all
I would refer you to the picture that Fastrack has of his prints.
the pic in the "made" part of this page
the smaller polar bear cubs in it are maybe 2 inches tall
at 1 inch i suspect the details will become more "blurred".
it is a matter of a number of variables.
how good is the printer? (this is a really big factor!)
what was the slice (the z)
speed of print can be a factor (slower is typically better for quality
but not necessarilly)
and really a lot of other varibles.
not trying to be obtuse, just letting you know there are many factors.
the short answer is
if i was looking to print this at 1 inch and wanted a good print
i would probably slice at .15
and if the print was not good i would go to the slower replicator default
if you are using a different printer i can't really advise.
but i would highly recomend experimenting to get a good feel for the printer settings.
oh, o.k. thank you. Do you know how it looks at 1in.? Does the design still stand up? by which I mean look good.
Liked Byview all
Give a Shout Out
You must be logged in to post a comment.