Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Solidoodle 2 NEMA14 fan mount
3
Likes
113
Downloads
698
Views
Published on December 18, 2012
Description
This is another NEMA14 stepper motor fan mount. I specifically wanted one for my Solidoodle2 because the x-axis motor gets very hot but I wasn't satisfied with the other two things I found on here. One didn't have any holes for the air to actually come out on top and the other was to asymmetric for me.
So, here is my take on it.
I will try to improve the airflow still because even now there is not much coming through. Maybe anybody has suggestions how to improve this without increasing the footprint too much?
So, here is my take on it.
I will try to improve the airflow still because even now there is not much coming through. Maybe anybody has suggestions how to improve this without increasing the footprint too much?
Instructions
I printed it with .3mm resolution and 20% infill (ABS). No support needed.
Just screw the fan to the bottom. To power the fan I used one of the 12V pins on the Solidoodle board. If you want you can add some heat sinks to the sides of the motor to improve cooling.
Just screw the fan to the bottom. To power the fan I used one of the 12V pins on the Solidoodle board. If you want you can add some heat sinks to the sides of the motor to improve cooling.
License
Solidoodle 2 NEMA14 fan mount by technicallyfeasible is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3D Printer Accessories
You must be logged in to post a comment.