Bezel/Clock Fonts and a 41mm Bezel Cap
1
Likes
226
Downloads
471
Views
Published on December 19, 2012
Derived from
OpenSCAD Bitmap Fonts Module
by tbuser
Description
Trimmed down the BMP fonts to only those that would be used on a watch bezel, used the Tbuser framework to create double digit numbers 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, a round pip, a bar, and a triangle.
Attaching an incomplete gen2 watch bezel cap with blank 5min markers.
Attaching an incomplete gen2 watch bezel cap with blank 5min markers.
Instructions
Use this scad module to make a watch face or fill in numbers on a dive watch bezel, the STL is so you can preview the additional double number fonts I made.
You can actually print the blank bezel cap, there are square marks every 30 degrees for 5min markers, fits 41mm bezel watches like the newer GMT Master, Submariner, etc.
Planning to add the font to the blank watch bezel for a complete watch accessory that will temporarily convert a GMT watch into a dive watch and provide some additional protection.
You can actually print the blank bezel cap, there are square marks every 30 degrees for 5min markers, fits 41mm bezel watches like the newer GMT Master, Submariner, etc.
Planning to add the font to the blank watch bezel for a complete watch accessory that will temporarily convert a GMT watch into a dive watch and provide some additional protection.
License
Bezel/Clock Fonts and a 41mm Bezel Cap by biketool is licensed under the Attribution - Share Alike - Creative Commons license.
More from biketool
More from Signs & Logos
You must be logged in to post a comment.