Advent Day 19 Santa Hat - No Support
5
Likes
69
Downloads
790
Views
Published on December 19, 2012
Derived from
Advent Calendar Day 19
by pleppik
Description
This is the quick way to print the Day 19 Santa Hat without the need for support.
Instructions
Print both sides and use a drop of superglue to stick both parts together.
Make sure you slice with 0.2mm or lower layers, use about 20% infill. 2 shells are also a good idea.
Make sure you slice with 0.2mm or lower layers, use about 20% infill. 2 shells are also a good idea.
You must be logged in to post a comment.
License
Advent Day 19 Santa Hat - No Support by RichRap is licensed under the Attribution - Creative Commons license.
More from RichRap
More from Toys & Games
Thanks!!! I would much rather glue together 2 pieces than spend an hour trimming support material, besides, support uses a lot of plastic and doesn't always work that great