Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Ians Upgrades Gear Sun
0
Likes
120
Downloads
1006
Views
Published on December 20, 2012
Derived from
Automatic Transmission Model
by emmett
Description
I printed this whole gear box out with my ultimaker and found that the central sun was super super tight. so i reworked the gears to be 1mm saller, also i made the inside whole half a mm bigger, i think this could be down to colling and PLA expansion, but now it workds for me, hope it helps. Ian
ps. also cut away some of the fat on this model. so it prints now in 30 minutes at 100 speed.
Ian :-)
ps. also cut away some of the fat on this model. so it prints now in 30 minutes at 100 speed.
Ian :-)
Instructions
I printed this whole gear box out with my ultimaker and found that the central sun was super super tight. so i reworked the gears to be 1mm saller, also i made the inside whole half a mm bigger, i think this could be down to colling and PLA expansion, but now it workds for me, hope it helps. Ian
ps. also cut away some of the fat on this model. so it prints now in 30 minutes at 100 speed.
Ian :-)
ps. also cut away some of the fat on this model. so it prints now in 30 minutes at 100 speed.
Ian :-)
License
Ians Upgrades Gear Sun by ultimakerinleipzig is licensed under the Attribution - Share Alike - Creative Commons license.
More from ultimakerinleipzig
More from 3D Printer Accessories
You must be logged in to post a comment.