ArduCopter External Status Led Holder
2
Likes
63
Downloads
573
Views
Published on December 20, 2012
Description
Holder for 2x 10mm LEDs to mount externally on your rig, used to show GPS/ARM Status
Instructions
Parts Needed
2 x 10mm LED's
2 x 100ohm Resistors
2 x Servo connectors
Instructions
Attach the Led Cathode to the servo connector ground.
Attach 100ohm resistor between the signal on the servo connector and Led Anode
Mount in Led Holder with some hot glue or CA
Mount on your Rig where desired
Connect to ArduPilot on channels A7 and A6
In Mission Planner Set LED_MODE = 3 (this sets GPS/ARM status on ports A7/A6)
enjoy.
2 x 10mm LED's
2 x 100ohm Resistors
2 x Servo connectors
Instructions
Attach the Led Cathode to the servo connector ground.
Attach 100ohm resistor between the signal on the servo connector and Led Anode
Mount in Led Holder with some hot glue or CA
Mount on your Rig where desired
Connect to ArduPilot on channels A7 and A6
In Mission Planner Set LED_MODE = 3 (this sets GPS/ARM status on ports A7/A6)
enjoy.
License
ArduCopter External Status Led Holder by WickedAndy is licensed under the Attribution - Creative Commons license.
More from WickedAndy
More from R/C Vehicles
You must be logged in to post a comment.