Pulley for T 2.5 Belt
by ArjanG, published
Pulley for T2.5 Belt Mendel Prusa. Fits a standard 608ZZ (Roler Skate) bearing. BIG IMPROVEMENT IN PRINT QUALITY!
Print the Pulley, using less than 0.25 mm per layer. Adjust the speed a bit down. Part should print in about 22 minutes at 60mm/sec. The underside (not visible in the STL file) has lips to snap in the 608ZZ bearing.
With the ball bearings on the T2.5 belt, its a bit like having square wheels, exaggerated. The belt on the bearing causes a small sinus like movement. But you have to multiply that because both the x and the y axis are running on belts/bearings. This pulley has the same teeth as the belt and makes the printer run much smoother. You can see this in the print result. Far less "moire" in the print. Besides this you save bearing, only 3 needed instead of 6.
Liked ByView All
Give a Shout Out
Pulley for T 2.5 Belt by ArjanG is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure ArjanG would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).