Loading

Qui gon jin's Lightsaber

by sirmakesalot, published

Qui gon jin's Lightsaber by sirmakesalot Dec 21, 2012

Featured Thing!

Description

Another lightsaber mega project. This one is a likeness (though not an accurate one) of Qui gon jin's lightsaber that Kenobi used to slice Darth Maul in two! I incorporated a BlinkM into it so I can choose the colour.

Recent Comments

view all
on a related note, make it 28.00 cm, in small parts less than 8 in tall, like the lightsaber w internal componets
i just bought a 3d printer and loved making the lightsaber w internal componets. could you make a few more lightsabers for me to print?
(possibly mace windu's)
Yeah it did turn out looking like a hunk of meat. It is a tough thing to replicate.I use the megasaber project for the same end also.

More from Props

view more

Makes

Liked By

view all

License

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Print each component in the zip file once but when setting up your slicing profile, use multiply to create 3 rows of four columns to generate twelve body rings. (print two to tweak your profile so they fit well)
All parts will print without support and I left a tolerance of .2mm for all intersecting parts.
I used my own slicing profile not the Replicator accelerated defaults; the parts come out over size and wont fit well.
I used .2mm layer height, 2 extra shells and 20% infill. The parts are thin and will print very nicely and be smooth and solid.
Assembly is as follows,
Stack all 12 of the body rings to make the handle body then put the top section on, glue them as you go and make sure they are straight.
I used acetone to put the outer sheath together from the inside so it didn't leave a mess,
I took a piece of 1 inch acrylic rod, sanded it down and polished one end to make the light blade.
Using a BlinkM RGB programable light to change the colour, I taped it with electrical tape to seal it on the end of the blade inside the 'saber. You could make the program look like the blade is shorting in and out.
I wired up 2x 3V button cell batteries on a removable wire and there it glows!
I wrapped electrical tape as a spacer to fit the saber to the blade nicely and easily. It makes a good light seal also.
Then put the sheath on the bottom components post,
Slide the body section together.
I went a step further and used spray foam and some paint to mimic the blade melting through a wall or door. I used a bright orange base with red and yellow highlights.
It makes a great light or table decoration! A real conversation starter too!
The republic awaits!
on a related note, make it 28.00 cm, in small parts less than 8 in tall, like the lightsaber w internal componets
i just bought a 3d printer and loved making the lightsaber w internal componets. could you make a few more lightsabers for me to print?
(possibly mace windu's)
I reckon that the fire/lava looks like a chunk of meat. Awesome lightsabers by the way. Your lightsaber with internal componets is what I use to impress my friends of what a 3D printer can do.
Yeah it did turn out looking like a hunk of meat. It is a tough thing to replicate.I use the megasaber project for the same end also.
Top