Replicator Door Knobs
1
Likes
96
Downloads
546
Views
Published on December 21, 2012
Derived from
Complete Replicator Front door
by drandolph
Description
These are Knobs designed to fit in the two holes on the front of the doors from the Complete Replicator Front door by drandolph.
Instructions
I printed mine at...
Object infill (%) 15
Layer Height (mm) .2
Number of shells 0
Feedrate (mm/s) 50
Travel Feedrate 30
I do have Acceleration turned on.
They should press in to the holes without any modification. Then I used Weld On #16 to glue the parts to the acrylic windows. I just used a small amount on the lower lip.
Object infill (%) 15
Layer Height (mm) .2
Number of shells 0
Feedrate (mm/s) 50
Travel Feedrate 30
I do have Acceleration turned on.
They should press in to the holes without any modification. Then I used Weld On #16 to glue the parts to the acrylic windows. I just used a small amount on the lower lip.
License
Replicator Door Knobs by TCorgard is licensed under the Attribution - Share Alike - Creative Commons license.
More from TCorgard
More from 3D Printer Parts
You must be logged in to post a comment.