Pibow Raspbery PI Enclosure Screw Hole Rod and Cap
3
Likes
89
Downloads
1112
Views
Published on December 22, 2012
Description
The Pibow Enclosure at thingiverse.com/thing:33443 requires four 30 mm nylon screws. I created this to replace those if you laser cut an enclosure.
This thing was made with Tinkercad. Edit it online tinkercad.com/things/bAiNA4G9ewV
This thing was made with Tinkercad. Edit it online tinkercad.com/things/bAiNA4G9ewV
Instructions
No instructions provided.
You must be logged in to post a comment.
License
Pibow Raspbery PI Enclosure Screw Hole Rod and Cap by albill is licensed under the Attribution - Creative Commons license.
Of course, I made this after I wound up ordering 100 M3 x 30 mm nylon screws and nuts...