hobbed bolt tool m6
3
Likes
153
Downloads
1706
Views
Published on December 22, 2012
Description
This thing was made with Tinkercad. Edit it online tinkercad.com/things/3KgXbDUkTnb
Instructions
This has been modded form the KNRLR to fit 6mm bolts, also cut of corner to give more room for m3 screw.
I have put the parts together on one table apart from dremel attachment that's in a separate file,which is a copy of the one from the original KNRLR
I have printed and looks ok, see picture
I have put the parts together on one table apart from dremel attachment that's in a separate file,which is a copy of the one from the original KNRLR
I have printed and looks ok, see picture
License
hobbed bolt tool m6 by mouserunner is licensed under the Attribution - Share Alike - Creative Commons license.
More from mouserunner
More from 3D Printing
ok i have printed it and it came out good, have loaded picture.
had to run a 6mm and 3mm drill down holes to clean but other than that its OK.
will try it tomorrow on a bolt.
hope someone gets some use out of it and thanks to chopmeister for the original design