by QuantumConcepts, published
This is a simple stocking hanger which can be hung atop a mantle. I'm using it on a mantle that whose top is an inch-thick piece of wood. The bottom of the hanger hang underneath the mantle and the stocking balances pretty well on it.
Recent Commentsview all
Liked Byview all
Give a Shout Out
It should be strong so I printed it with PLA using these settings:
- Layer Height: .2mm
- Perimiters: 4
- Solid Layers: 4 top; 4 bottom
- Infill: 25%; honeycomb; every layer*
25% infill in this small pieces may be pointless, probably should just print it solid instead.