Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Imperial Ornament Hanger
5
Likes
76
Downloads
509
Views
Published on December 22, 2012
Description
This is for hanging those Star Wars style ornaments or just about anything else on your Christmas tree.
Instructions
Your settings or the scale may require some tweaking to ensure the hooks come out solid, however they still work quite well if your printer doesn't do the infill between the outer walls.
I used the following settings on an Ultimaker with ProtoParadigm's 3mm PLA. Wall thickness .65, layer height .2, print speed 50mm/s, temp 220... Retraction was enabled, but it's not really needed.
This is one of my entries into ProtoParadigm's Winter Wonderland Contest.
This works well with Nachimirs Vader flake, thingiverse.com/thing:14914
or iHeartRobotics Star Flake thingiverse.com/thing:14677
See also, mattersofgrey.com/diy-star-wars-snowflakes/
I used the following settings on an Ultimaker with ProtoParadigm's 3mm PLA. Wall thickness .65, layer height .2, print speed 50mm/s, temp 220... Retraction was enabled, but it's not really needed.
This is one of my entries into ProtoParadigm's Winter Wonderland Contest.
This works well with Nachimirs Vader flake, thingiverse.com/thing:14914
or iHeartRobotics Star Flake thingiverse.com/thing:14677
See also, mattersofgrey.com/diy-star-wars-snowflakes/
License
Imperial Ornament Hanger by engrkris is licensed under the Attribution - Non-Commercial - Creative Commons license.
You must be logged in to post a comment.