Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Micro Spider-H Quadcopter
7
Likes
106
Downloads
1363
Views
Published on December 23, 2012
Description
This is a prototype Micro Spider-H Quad I've been working on. The design is intended to replace the conventional wood designs that most people use for H-Quads. The arms are angled outwards at 25 degrees so that any load encountered during a crash will be felt mostly as an axial load rather than a perpendicular load. The center spine is arched upwards slightly, partially for aesthetics and partially because it helps the arms form a stronger bond with the spine. I haven't been able to test/weigh this quad yet.
Instructions
This Micro Spider H-Quad is designed to work with the following components:
Turnigy 1811 2900KV Motor
Turnigy Plush 6A ESC
KK2.0 (or any controller with 45mm hole spacing)
M2 Shouldered Screws (for mounting the controller and the motors)
The print will require support material - some below the spine arc and some below each of the arms, as they are all filleted.
Turnigy 1811 2900KV Motor
Turnigy Plush 6A ESC
KK2.0 (or any controller with 45mm hole spacing)
M2 Shouldered Screws (for mounting the controller and the motors)
The print will require support material - some below the spine arc and some below each of the arms, as they are all filleted.
You must be logged in to post a comment.
License
Micro Spider-H Quadcopter by ukarmy04 is licensed under the Attribution - Share Alike - Creative Commons license.
More from ukarmy04
More from R/C Vehicles
Nice job. Did I send you the models for the motors and ESCs or did you make them? I have the KK2 modeled too.
Yeah, I got bored during finals so I decided to model them. Could you send me the KK2?