MacPro 2.5 inch Carriage
7
Likes
68
Downloads
1086
Views
Published on December 23, 2012
Description
This carriage replaces the original aluminium carriage for 3.5" disks that come with a MacPro. Due to some unfortunate design decisions the original carriages can't be used with 2.5" disks. This carriage fits in the slides of the MacPro case and supports the locking mechanism.
Instructions
When printing make sure that you reduce warp as much as possible, any warp will tighten the fit into the MacPros slides. Also check that the parts with minimum Thickness will not be printed with over 1.75mm thickness, otherwise it won't fit. Make sure to adjust first layer thickness accordingly.
License
MacPro 2.5 inch Carriage by Srek is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.