Replicator Rear Extruder Cable Clip
0
Likes
68
Downloads
471
Views
Published on December 23, 2012
Description
My rear Replicator extruder cable clips broke so I decided to make new ones. Complete with mounting holes. Use old hardware to mount. Install takes under 5 minutes for both.
Instructions
Uninstall stock clips from rear of replicator. Print and install new clips.
.27 layer height, 10% infill. I printed on its side with external support.
.27 layer height, 10% infill. I printed on its side with external support.
License
Replicator Rear Extruder Cable Clip by Caboose is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.