Autobot vs Decepticon
17
Likes
132
Downloads
1383
Views
Published on December 23, 2012
Description
A 3D block of both Autobot and Decepticon logos.
I printed this with 5% infill, .15 layer height, and 3 shells on my Replicator 1 and it took 17 hours. I've fixed the model, so no more issues... hopefully :)
I printed this with 5% infill, .15 layer height, and 3 shells on my Replicator 1 and it took 17 hours. I've fixed the model, so no more issues... hopefully :)
Instructions
Print with raft and supports
I typically do 5% infill
.25 layer height
2 shells
Design has small columns holding all pieces together so be careful when removing supports.
I typically do 5% infill
.25 layer height
2 shells
Design has small columns holding all pieces together so be careful when removing supports.
License
Autobot vs Decepticon by tbm0115 is licensed under the Attribution - Share Alike - Creative Commons license.
More from tbm0115
More from Signs & Logos
You must be logged in to post a comment.