Dropcam Tripod Mount
5
Likes
214
Downloads
1376
Views
Published on December 24, 2012
Description
Very much a work in progress. I'm still adjusting the ring where the camera goes.
Update 12/25/2012 - Updated files are mk2
Update 12/25/2012 - Updated files are mk2
Instructions
This thing will eventually be two parts. One that screws to the shoe and one that holds the camera. The two will be joined by a piece of 3mm filament. Or at least thats the plan so far.
Print this thing however you want, put your Dropcam camera on it and fasten to your tripod shoe.
Update 12/25/2012 -
I printed these in two parts. Assembly is: insert tab-A into slot-B and align with a gentle tap of a hammer or putty knife handle.
Tweaking of the ring that holds the camera continues.
Print this thing however you want, put your Dropcam camera on it and fasten to your tripod shoe.
Update 12/25/2012 -
I printed these in two parts. Assembly is: insert tab-A into slot-B and align with a gentle tap of a hammer or putty knife handle.
Tweaking of the ring that holds the camera continues.
You must be logged in to post a comment.
License
Dropcam Tripod Mount by Reuben is licensed under the Attribution - Share Alike - Creative Commons license.
what is the inside diameter of the ring? 2 and 1/4?
thanks
I found that a diameter of 46mm (1.811 inches) was about right.