RAMPS mount for MendelMax
3
Likes
121
Downloads
805
Views
Published on December 24, 2012
Description
This is a bracket to mount a RAMPS board horizontally, on the inside of the bottom extrusions on my MendelMax. I like having the wires at the bottom, it is way less messy. I also like having the electronics contained within the frame.
I recommend printing with support structures unless you can reliably pull off godlike bridges.
Sorry for the messy .scad file, I made this in less than an hour, it was needed quite urgently. I may clean it up in the future.
I recommend printing with support structures unless you can reliably pull off godlike bridges.
Sorry for the messy .scad file, I made this in less than an hour, it was needed quite urgently. I may clean it up in the future.
Instructions
Required hardware:
2x M5-10 screws with washers
2x t-slot nuts appropriate for your extrusions
3x M3-30 screws
3x M3 nuts
6x M3 washers
Add another set of M3 screws, nuts and washers if you want the 4 corners screwed in.
2x M5-10 screws with washers
2x t-slot nuts appropriate for your extrusions
3x M3-30 screws
3x M3 nuts
6x M3 washers
Add another set of M3 screws, nuts and washers if you want the 4 corners screwed in.
License
More from jothan
More from 3D Printer Parts
You must be logged in to post a comment.