Loading

RAMPS 1.4 Box with Smart Adaptor

by drandolph, published

RAMPS 1.4 Box with Smart Adaptor by drandolph Dec 25, 2012

Thing Info

10253Views 1550Downloads Found in 3D Printer Parts
Report Thing

Summary

The original box was nice but didn't fit the Smart Adaptor and had a few glitches.

Instructions

The box shrinked too much when printed in ABS so I scaled it slightly to be printed in ABS. I also noticed that a few of the connectors were too close to the edge for the rails to work on the left side. So this has a notch for those and now it locks in nicely. The Smart adaptor sticks off the right side so I made a notch to receive that. I also made a pass through hole for the Smart Adaptor cables on the top plate. I lenghten the box to make room for the Smart Adaptor. Now it will hold a fully loaded RAMPS 1.4 board minus the sd reader since that is on the Smart control panel which this box now handles.

More from 3D Printer Parts

view more

Thing Info

10253Views 1550Downloads Found in 3D Printer Parts
Report Thing

Makes

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

i printed this in pla with no problems!

SInce it's scaled to be printed in ABS. Can be printed in PLA without modification?

Top