Parametrised Puddle Jumper
Description
A spinning flying toy thingy.
This is a copy of thing:37110, with the hole rotated 45 degrees to avoid the need for support, and most things parametrised.
This is a copy of thing:37110, with the hole rotated 45 degrees to avoid the need for support, and most things parametrised.
Instructions
Printed on a Reprap mendel with .15 layer height and 50% fill. Use as little fill as you can handle to make this fly better.
Cut the disks from the blades (they are needed to keep it planted to the print bed).
Spin the puddle jumper between the palms with a quick motion. My cat loves chasing it around the room.
It is possible you will need to print the parts separately to avoid a blob when the printing changes from the insert and rotor to rotor alone.
[instructions mostly from the parent]
Cut the disks from the blades (they are needed to keep it planted to the print bed).
Spin the puddle jumper between the palms with a quick motion. My cat loves chasing it around the room.
It is possible you will need to print the parts separately to avoid a blob when the printing changes from the insert and rotor to rotor alone.
[instructions mostly from the parent]
You must be logged in to post a comment.
License
Parametrised Puddle Jumper by gringer is licensed under the Attribution - Share Alike - Creative Commons license.
More from gringer
More from Mechanical Toys
Nice job parametrisizing it.
[That's a made up word, so I can spell it any way I want. ;-) ]