Miniature Battery Box
0
Likes
40
Downloads
386
Views
Published on December 26, 2012
Description
Small box to hold 2 x 1.5 volt button batteries, LR1130 or AG-10 for powering a LED globe.
Instructions
Cut a paper clip into 2 parts as shown.
Push the smaller one right through the bottom of the box.
Put 2 x button batteries in negative down and then opush the U shaped paper clip through the two top holes to the far side to hold the batteries in and make the positive contact.
If you don't get a good contact depending on your printer settings, fold up a small piece of aluminium foil and place under the batteries.
Solder to your globe or connect with buldog clips.
Push the smaller one right through the bottom of the box.
Put 2 x button batteries in negative down and then opush the U shaped paper clip through the two top holes to the far side to hold the batteries in and make the positive contact.
If you don't get a good contact depending on your printer settings, fold up a small piece of aluminium foil and place under the batteries.
Solder to your globe or connect with buldog clips.
License
Miniature Battery Box by chaleg is licensed under the Attribution - Share Alike - Creative Commons license.
More from chaleg
More from Electronics
You must be logged in to post a comment.