Support for auxiliary fan
4
Likes
49
Downloads
664
Views
Published on December 27, 2012
Description
Small contribution, to cool the parts as they are printed, without having to set the fan to the extruder carriage.
Instructions
You will need:
1 M8 threaded rod
1 Barclamp of I2 Prusa
3 nuts and 3 washers M8
1 M8 threaded rod
1 Barclamp of I2 Prusa
3 nuts and 3 washers M8
License
Support for auxiliary fan by Black_Knight is licensed under the Attribution - Share Alike - Creative Commons license.
More from Black_Knight
More from 3D Printers
Big fan on hotbed might cool down the hotbed too much. Be careful with big fans.
I still prefer small fan on carriage, you don't need many air to cool a bit.
By the way, I had seen your posts and really liked them.
A greeting.
Thanks for your suggestion, fact is that the plastic cooling needs little if any, use the fan to cool over the top of estrusor and especially the engine, however was the only size available to him.