Semi-Auto Rubber Band Gun Plates for 120x120 build platforms
38
Likes
1866
Downloads
4849
Views
Published on December 27, 2012
Derived from
Rubber band gun simi auto
by gtcdman27
Description
Liked the original but had to slice it up to fit on my TOM's 120x120 build area.
Instructions
Just like the original use 1/4" dowels for assembly. Also prepare to sand the parts to make them fit well.
The dowels I uploaded are just smaller than 1/4" but if you drill out the holes to 1/4" they fit snug. Drill out the other holes to 17/64" and everything should fit together.
If you have problems with the ratchet wheel try printing out this derivative thingiverse.com/thing:39464
I just used superglue to attach the barrel. It was fairly flat and only required a little sanding.
Good Luck!
The dowels I uploaded are just smaller than 1/4" but if you drill out the holes to 1/4" they fit snug. Drill out the other holes to 17/64" and everything should fit together.
If you have problems with the ratchet wheel try printing out this derivative thingiverse.com/thing:39464
I just used superglue to attach the barrel. It was fairly flat and only required a little sanding.
Good Luck!
You must be logged in to post a comment.
License
Semi-Auto Rubber Band Gun Plates for 120x120 build platforms by MacGyver is licensed under the Attribution - Creative Commons license.
More from MacGyver
More from Mechanical Toys
How much fill and shells do you guys recommend?
I used 1 shell and 5% infill, however you might want to use 10% infill or higher for greater strength.