Spool Clip - 1kg of 1.75mm filament
by WetNeon, published
This clip fits my 1.75mm, 1kg (2.2lbs) spools from OCTAVE and Jet.
This is a derivative of k1nc41d's spool clip.
Recent Commentsview all
Liked Byview all
Give a Shout Out
You may need to thread the filament through the top printed side of the hole since it will most likely be bigger. So if the size on the bottom printed size is a bit smaller it will secure it in place.
Please let me know if your printer prints the hole either too big or too small for your 1.75mm filament.