Planetary gear Parking Disc
13
Likes
2356
Downloads
944
Views
Published on August 31, 2010
This thing was Featured on September 3, 2010
Derived from
Planetary gear calling card
by phidauex
Description
Cuts nicely with 2mm endmill. I did the engraving of numbers etc. with 55degree V carving bit. This is quite large (about 16cm x 17cm) so you might want to scale it down a bit.
Please note that this doesn't comply with parking disc standards in Europe so you could get a ticket if you use it.
Please note that this doesn't comply with parking disc standards in Europe so you could get a ticket if you use it.
Instructions
Icluded are Artcam 2008 files and a basic Dxf
.cnc files were used to cut this with mach3 using 2mm endmill and 55 degree V-groove engraving bit.
.cnc files were used to cut this with mach3 using 2mm endmill and 55 degree V-groove engraving bit.
You must be logged in to post a comment.
Anonymous
on
September 1, 2010
said:
It looks like it might contain a clockwork to make it move automatically.
That would surely be practical for the driver, and as surely is forbidden.
The trouble is that it looks like it, but is innocent, so you probably will get into trouble for nothing (for looks and design).
License
More from Metalfusion
Paint it blue and the dial white with the black lettering and have the gearing visible in the back. You get to have cool gears to look at while setting it and the pigs see an official looking parking disk.