Simple 9mm Finger Band
by xAuSolarisx-Ros3, published
Here is a simple finger band which could be possibly used for rings or anything of the sort.
Liked Byview all
Give a Shout Out
The band's width is 1mm, so some may need to set their extrusion rate a little lower. It works perfectly with Printrbot Jr.
Printrbot Jr Slicer Settings:
Temp: 195 Bed Temp: 0 Layer height: 0.5 Perimeters mm/s: 30 Small Perimeters mm/s: 30 Infill mm/s: 60 Solid Infill mm/s: 60 Bridges mm/s: 60
You may want to add a 2-loop skirt for safety.