Yet another leveling calibration sheet
9
Likes
261
Downloads
833
Views
Published on December 29, 2012
Description
Here's a calibration sheet that I made which makes it easy to level a Makerbot Replicator.
This one also has an affordance (the attached square) to make it easy to keep track of where you are in your measurement in case you get lost, as I always do.
This one also has an affordance (the attached square) to make it easy to keep track of where you are in your measurement in case you get lost, as I always do.
Instructions
Print it out without a raft, and use your calipers to measure the thickness of each corner. Adjust your leveling screws and reprint until all four corners are the same thickness. Ideally this thickness should be slightly less than your layer thickness value.
You must be logged in to post a comment.
License
Yet another leveling calibration sheet by fluffy is licensed under the Attribution - Share Alike - Creative Commons license.
More from fluffy
More from 3D Printing Tests
am i supposed to understand that procedure?
What don't you understand?