Parametric Spoon from Inkscape outline

by clubclay, published

Parametric Spoon from Inkscape outline by clubclay Dec 30, 2012

Thing Info

1533Views 599Downloads Found in Kitchen & Dining
Report Thing


I wanted to create a spoon from an outline in Inkscape using OpenSCAD, this is the first result.


When I printed with MakerWare, it left parts out (left spoon in picture), but ReplicatorG worked fine. As I'll actually be using this for liquids, I prefer the result from ReplicatorG at this time.

I've used free tools as I don't like it when the originals are paid packages, even though its possible to work from a Things .stl it's still better to have the entire toolchain available for everyone.

Photo's are from a print in Yellow PLA, the object is slightly scaled down to be 15cm long.

More from Kitchen & Dining

view more

Thing Info

1533Views 599Downloads Found in Kitchen & Dining
Report Thing

Liked By

View All


Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

Makerware 1.1 fixes the missing lines problem (nice job guys!) be sure to clear and then set again 'accelerated printing' when upgrading your firmware.

I appreciate you including the entire toolchain. :) What did you use to convert the SVG into a DXF? Thanks!

Inkscape can do a save as .dxf - the OpenSCAD manual refers to a walkthrough on the rep-rap forums - its a little fiddly, and you have to convert you curve to straight lines by adding points and converting the line type.