100 mm channel fan to 30 mm pipe adapter
5
Likes
173
Downloads
1161
Views
Published on December 30, 2012
Description
This is simple adapter for standard channel fan with 100 mm out to 30 mm pipe to be used with 3/4" water pipe adapter (http://www.thingiverse.com/thing:39745).
Instructions
Set walls thickness to 0.8 mm and print with normal or high quality.
This thing developed to be used with 3/4" water pipe adapter you can find here: thingiverse.com/thing:39745
Note: if you want to print directly from .STL file you'll need to flip Y-Z planes to place thing correct on printing table.
This thing developed to be used with 3/4" water pipe adapter you can find here: thingiverse.com/thing:39745
Note: if you want to print directly from .STL file you'll need to flip Y-Z planes to place thing correct on printing table.
You must be logged in to post a comment.
License
100 mm channel fan to 30 mm pipe adapter by mattheus is licensed under the Attribution - Share Alike - Creative Commons license.
Wont that put a lot of strain on the motor?
No, exit hole of 30 mm still large enough to not put too much straing on the motor. I tested, even if close exit hole completely - channel fan motor works fine (just all air going back to front of fan). So you should not worry of this.