Loading

honeycomb bowl

by Zampik, published

honeycomb bowl by Zampik Dec 31, 2012

Description

small bowl

Recent Comments

view all

I printed this last night in black PLA on my Replicator 2 and it turned out great. I used the default Standard-res settings (10% infill, 2 shells, .2mm layer height) and it worked very nicely. I tried it with supports first and the supports got totally messed up after about a minute so I cancelled the build and resliced it without supports. It printed just fine without them since the curve of the bowl is pretty shallow. Although the end result needs a little cleanup with the filament hairs in between the cells, I'm really pleased with this one. A++++ would print again.

it was printed with support. still some sanding required :-)

Wow, that came out a lot better than I thought it would. did you use support or just print it "au naturel"?

More from Kitchen & Dining

view more

Makes

Liked By

view all

License

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Comments

You must be logged in to post a comment.

bashmuttons on Dec 6, 2013 said:

I printed this last night in black PLA on my Replicator 2 and it turned out great. I used the default Standard-res settings (10% infill, 2 shells, .2mm layer height) and it worked very nicely. I tried it with supports first and the supports got totally messed up after about a minute so I cancelled the build and resliced it without supports. It printed just fine without them since the curve of the bowl is pretty shallow. Although the end result needs a little cleanup with the filament hairs in between the cells, I'm really pleased with this one. A++++ would print again.

cyclone on Dec 31, 2012 said:

Wow, that came out a lot better than I thought it would. did you use support or just print it "au naturel"?

Zampik on Dec 31, 2012 said:

it was printed with support. still some sanding required :-)

Top