Loading

Delta Bandsaw Zero Clearance Throat Insert

by bennettmarks439, published

Delta Bandsaw Zero Clearance Throat Insert by bennettmarks439 Dec 31, 2012

Description

This is a drop in replacement for the circular throat disk that sits in the bandsaw table.

Recent Comments

view all
I suppose it would be quite simple to add the bump.
Apparently ABS shrinks a bit more than PLA. You can adjust that in the SCAD.
I just finished printing one using white ABS and it fit very well though just a hair lower than the table surface. My original Delta band saw insert (like yours from the photo) has a bump that keeps the insert from rotating - I wonder if that's worth adding to the model.
Whoops. Here it is. I meant to put up the stl not the gcode.

More from Parts

view more

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Since this is zero clearance, you will need to turn on the bandsaw and cut a slot in the throat disk. Use the slotline on the top of the disk as a guide. The disk should drop in to the bandsaw table snugly. If your printer is generating out-of-round circles, then this won't fit. Tighten your belts and try again.
I just finished printing one using white ABS and it fit very well though just a hair lower than the table surface. My original Delta band saw insert (like yours from the photo) has a bump that keeps the insert from rotating - I wonder if that's worth adding to the model.
I suppose it would be quite simple to add the bump.
Apparently ABS shrinks a bit more than PLA. You can adjust that in the SCAD.
Great idea!
stl?
Thanks
Whoops. Here it is. I meant to put up the stl not the gcode.
Top