Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Solidoodle 2 Spool Holder
26
Likes
1225
Downloads
2380
Views
Published on January 1, 2013
Derived from
Solidoodle 2 Filament holder
by 3D_CC_design
Description
Replacement spool holder for the Solidoodle 2.
Instructions
I was a bit dissatisfied with the spool holder supplied with the Solidoodle 2. It forced me to position the printer very far from the wall and I felt it could be improved upon.
The holder is designed to accommodate a 1" PVC pipe. The pipe should be approximately 10.5" long. Light sanding on the flats mat be required for proper fitment. 8 small wood screws are also required for assembly
Honestly, it is a bit overbuilt and could be improved upon. Feel free to edit.
The holder is designed to accommodate a 1" PVC pipe. The pipe should be approximately 10.5" long. Light sanding on the flats mat be required for proper fitment. 8 small wood screws are also required for assembly
Honestly, it is a bit overbuilt and could be improved upon. Feel free to edit.
You must be logged in to post a comment.
iammagicmike
on
March 23, 2013
said:
just printed out mine and it works great! I just wood screws #4 x 3/4"
TheBogueRat
on
January 20, 2013
said:
Definitely overbuilt, but it is working great with the Solidoodle filament rolls. I made a spacer for the larger spools but there just isn't quite enough room for them so I have to slide it forward a little. Could use another inch to get the big ones to clear.
Thanks for the work!!
beavertank
on
January 9, 2013
said:
I couldn't get right_upright.stl to load properly so I checked it in netfabb and discovered it had negative volume. I ran it through the cloud version of netfabb and fixed it (here's the repaired file: https://www.dropbox.com/s/qaxa... ) so it ought to work now.
Nice design, though. Hopefully my print of it turns out.
License
Solidoodle 2 Spool Holder by gsterley is licensed under the Attribution - Share Alike - Creative Commons license.
More from gsterley
More from 3D Printer Accessories
It works fine on my soildoodle 3 too. I use 3/4 pvc with caps on the end. the caps fit snugly into the printed pieces.