GoPro Hero3 Lens Cap
by TheCase, published
Recent Commentsview all
I printed this in ABS at .2 height, 100% fill. It fits a little loose but snaps in place so it won't fall off. Keep in mind that this is not designed to fit on the Hero3+ because the plus doesn't have the indents for the tabs. I tried to put it on the plus and the tabs broke off, but it actually does stay on.
Liked Byview all
Give a Shout Out
Once the cap is over the lens, spin it so these notches catch in the retaining holes.
You must be logged in to post a comment.